Virtual CD Server - StorPoint

Reset to Defaults

If the system password is forgotten, or a necessary network protocol is disabled and cannot be restored, the reset button can be used to restore the out-of-the-box system defaults. This button is located on the rear panel of the unit, near the Ethernet connector.

1. Turn off the Virtual CD Server 8i.
2. Press in and hold the Push button while turning on the unit.
3. Hold the Push button until the Network indicator flashes at regular two-second intervals.
4. Release the Push button and wait at least two seconds (one flash of the Network indicator).
5. Press in and hold the Push button for at least five seconds until the Network indicator remains constantly lit.
6. Turn off the power.
7. Wait twenty seconds and then turn the power back on again. The unit is now reset to the factory defaults.